Follow these easy steps to get your Bosch WTA 3510 Dryer up and running in no time.

1. Unpack the Dryer

Carefully remove the packing material from the outside of the dryer.

2. Inspect the Dryer

Thoroughly inspect the dryer for possible freight or cosmetic damage prior to installation.

3. Position the Dryer

Move the dryer so that it is within four feet of the desired installation position.

4. Exhaust Duct (Model WTA 3510 only!)

The WTA 3510 must be exhausted to the outdoors. Connect the exhaust ducting system to the dryer exhaust outlet.

5. Electrical Connection

The Bosch dryer comes with a 4-wire power supply cord pre-installed. Plug the 4-wire power supply cord into the 4-wire receptacle of the proper rating. If your receptacle is a 3-wire receptacle, you must obtain a 3-wire dryer cord and replace the existing cord.

6. Condensate Hose Connection (WTL 5410 only)

Connect the condensate drain hose to the dryer. Secure the other end at a nearby sink or drain.

7. Final Check List

Review the electrical requirements and make sure all steps were performed properly.

8. First Use Preparation

Check the voltage on the rating plate, wipe the interior of the drum with a damp cloth, and inspect the dryer for cosmetic damage.

Back to Home

Bosch WTA 3510

;